We will check on this today and make updates. Thank you for letting us know!

I appreciate your time.

We have made some adjustments to prepare for the school traffic starting next week and will check it during the week to see if it requires any additional changes.

Thank you for using SeeClickFix!

Work has been completed at this location. Thank you for using SeeClickFix!

Thank you for looking into this. I want to make sure I am 100% clear on this matter. This is preschool year, no buses and no parents dropping kids off and traffic is backing up down Peeler waiting to turn on to Tilly Mill at the Church. If the light cycle stays setup at current and as in years past, this is not acceptable. There needs to be a solution that allows traffic to clear Peeler.

I am sorry to say, that "no turn on red" sign probably needs to come down if no traffic light solution is available.

This needs to be a rapid switch light.

The City of Dunwoody has received this issue, as service request #5883. Currently, we are working on this, please check back for status updates.

Time was added to the Peeler side this morning. We will check again during the next week to see if it is sufficient.

The "no turn on red" sign has to stay because of the distance drivers can see at the intersection, but an arrow to run along with the Tilly Mill left turn phase may be added soon.

Modifications and adjustments are complete. Thank you for using SeeClickFix!

This issue is not fixed. During NON-rush hour periods, with no cross traffic on Tilly Mill, the light takes well over a minute to change for those on peeler turning right and left onto Tilly Mill. During non rush hour the Tilly Mill traffic should be far shorter duration. Is there no sensor at this intersection?

Signal timing adjustments are complete at this location. The cycle length has been shortened on weekends and non-peak periods.
Thank you for using SeeClickFix!

Fantastic! Thank you.

Work has been completed in coordination with this issue. Thank you for using SeeClickFix!

Thanks for fixing this request!